Smoothieware Firmware Settings
Probe device configuration
Smoothieware provides a very good writeup on setting up an NC switch as a Z-probe in its docs. See smoothiware.org/zprobe
Add the following to the smoothie config file :
gamma_min_endstop nc # normally 1.28. Change to nc to prevent conflict, not needed on Azteeg X5
zprobe.enable true # set to true to enable a zprobe
zprobe.probe_pin 1.28^ # pin probe is attached to if NO add !
zprobe.slow_feedrate 5 # mm/sec probe feed rate
#zprobe.debounce_ms 1 # set if noisy
zprobe.fast_feedrate 100 # move feedrate
zprobe.probe_height 5 # how much above bed to start probe NB only needed for G32 on delta
zprobe.return_feedrate 0 # feedrate after a probe, default 0 is double of slow_feedrate (mm/s)
zprobe.max_z 200 # maximum default travel for the probe command, will use gamma_max if not defined
